Tag: REVERB DELAY
-
Plate Reverb
General – Plate Reverb is a Large, Thin Sheet of Metal Suspended Upright Under Tension on Springs – Transducers Attached to the Plate Transmit a Signal that makes the Plate Vibrate, causing Sounds – a High Initial Diffusion – Relatively Bright and Colored Sound – Plates have an Instant Onset of Reverberation – Plates have…
-
Reverb
General – a Reverb can be Viewed as a Whole Bunch of Parallel Resonators – Each Like a Little Bell that Rings Out when Excited by the Input Being Close Enough to it in Frequency – Basically there is a Source Sound Wave that Goes Out and Builds an Initial Reverberation at a First Boundary…
-
RT 60
– The Length of the Reverb Tail, the Time it takes for the Reverb to Decay to a Level 60dB Lower that the Original Level – Often seen in Reverbs but also relevant for Measurements of Rooms etc. – Describes the necessary Time it takes, until a Test Tone “Lands” in the “Diffuse- Field” by…