Tag: EDM

General Stereo Mix STEM Mix Listening Volume 1) Fixed Monitor, Ideally 80 to 85 SPL for Most Linear Listening Experience and Best Decisions 2)  Never Switch Monitor Levels Constantly 3)  But Listen from Time to Time Louder and Check if the Mid Range is Not Too Excessive 4) And Listen from Time to Time Very…

General a) EQ Low Cut Around 20Hz to 30Hz  b) Bit of Compression (RMS Mode, No Auto Gain) c) EQ to Fix Problem Areas and / or Boost to Make Up Gain the Compression Before d) Saturation Plugins e) Multiband Compression (if Track Needs it) f) Limiter or Clipper Workflow 1) Start the Mastering by…

1) Digital EQ 2) Glue Comp 3) Multiband Comp 4) Saturation 5) Parallel Comp

EQ 1) Analyzer with Average / RMS Reading and Slow Update (Not a Moment to Moment Peak Display) 2) Clean EQ (Nugen SEQ) to Balance Spectrum from Roughly 100Hz to About 5kHz 3) Now you Should have a Rather Big Bump from 100Hz Downwards and a Rather Flat Response from 100Hz to 5kHz 4) Now…

1) Use a Dynamic EQ at Around 20Hz with a Low Shelf that Dynamically Reduces Low End when there is Too Much 2) Use a Dynamic EQ at Around 12kHz with a Peak that Dynamically Reduces Harsh Top End when there is Too Much 3) Reduce Transient Information on Drum Buss and 2 Buss by…

General Workflow 1) Start to Master the Loudest Possible Version by Taking your Loudest Song Part and Work Out the Master Over that Level  2) Then Aim for the Dynamic Version by Reducing 2 dB of RMS and Peak from the Loud Master 3) Then Start to Prioritise if it is Going to Radio, Stream…