Yendo Starritz

All About Music Production

Tag: BASS

  • Bass Control Mix and Mastering Tip

    Yendo Starritz
    in

    General Workflow 1) Insert a Multiband Dynamic Equaliser (Multiplicity) or Several Dynamic Equaliser 2) Then Use a Parallel Compressor in the Low Frequencies

  • Sub Bass for iPhone

    Yendo Starritz
    in

    Version 1 1) First Add a Tonal Balance Instance to See How the Mix Behaves 2) Insert a EQ and Low Pass at Around 100Hz / 12dB Oct, i.e. this Reflects the Missing Low End on the iPhone (iPhone Cuts Below 100Hz) 3) Now Add a Saturation Tool on the Sub Bass and Add Upper…

  • Split Bass Before Setup Kick vs Bass

    Yendo Starritz
    in

    1) Split the Original Bass into 2, a Sub Bass Part and a Bass Part – i.e. EQ High Frequency Bass with a 24dB Low Cut at 80Hz (Q at 1 or Default)  – then a 24dB High Cut EQ for the Low Frequency Set to 100Hz (Not 80Hz) with a Q at Around 0.500…

  • 3 Ways to Make Sub Bass Stand Out

    Yendo Starritz
    in

    General – Another Issue can be Masking Caused by the Very Little Headroom on Phones, i.e. a Loud Kick will then Mask the Bass Fix a Sub Bass that has a Chorus Effect from Cancelling Out 1) Duplicate the Sub Bass that has a Chorus Effect and Call One = Top and the Other =…

  • 4 Ideas to Make the Bass Cut Through 

    Yendo Starritz
    in

    1) 1176 Compression, Ratio 8, Fast Release, Attack at 3 2) Adding Distortion Such as Sans Amp 3) Push the Midrange Instead Low End, Push Bass Around 1kHz, e.g. 9dB at 1.3kHz, Optionally Use a De-Ess / De-Click Tools After to Manage Pick Ups from an Electric Bass that Got Pushed by the Midrange Boost…

  • Serial Bass Compression Tip

    Yendo Starritz
    in

    General Insert 1st Compressor (No Make Up Gain from Start) 1) Ratio 4:1 2) Hard Knee 3) Threshold for 5dB – 10dB of GR 4) Now Compensate with Make Up 5) Set Release to Medium Release or Auto Release  6) Adjust Attack, Make Attack Aggressive / Too Far so you Hear the Bass Getting Dull…

  • EQ Bass Against Guitar

    Yendo Starritz
    in

    General Workflow 1) First Insert EQ on the Guitar 2) Now Insert EQ on the Bass and Enhance with Peak Bands Around 70Hz, 260Hz, 1kHz and 6kHz (All by Max 3dB, Rather Broad Default Q) 3) Now Insert a Multiband Compressor on the Guitar Buss and SC the Bass into it 4) Insert a Multiband…